Fitting The Side Pod Skirts; Fitting The Floor Tool; Anbringen Des Abstreifers - Numatic TTV678-300 Mode D'emploi

Fitting the side pod skirts

Fig.9
To fit the side pod skirts, first remove the steel retaining strip already fitted to the pod (fig 9).
Align the steel retaining strip within the locating grooves of the rubber skirt and refit using existing screws (fig 10)
Periodically the side skirts should be examined and checked for wear and damage. Replace as shown above.
Fitting the floor-tool
Lower the floor-tool arm by moving the release lever to the upper position (fig.11)
Push floor-tool onto the holder and secure with the easy-fit securing pin (fig.12)
Push waste collection pipe onto the floor-tool; ensure a tight fit (fig.13)
Note: Raise floor-tool again before driving to the cleaning area (fig.14)
10
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Fig.11 Fig12
235670 02/12 (A09)
Fig.10
Fig.13
!
!
Fig.14