Machine Setup; Emergency Stop; Fitting The Brushes; Tipping The Brush Deck - Numatic TTB 4055/100T Mode D'emploi

Emergency Stop

This machine is fitted with an Emergency stop button,
instantly stopping the machine if accidentally reversed into the operator (Fig.18).

Fitting the brushes

Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
The Pad is retained using Numatic's own PadLoc system (ask your supplier for details).
Only use manufacturer supplied brushes.
TTB 4055T requires a 550mm brush or a 500mm pad.
TTB 4552T requires 2 x 280mm brushes or 2 x 280mm pad.
19
Safety gloves are recommended for the changing of used brushes.

Tipping the Brush Deck

21
Machine Set-Up
18
Fit the brush / pad to the drive chuck,
twist to lock the brush / pad in place
(Fig.19) (Fig.20).
To tip the deck into the down position
(Operating mode) Press in the brush
deck locking bar (Fig.21) and rotate the
brush deck (Fig.22).
To change to brush deck up position,
(Transit mode) simply lift the deck and
the spring loaded locking bar will
activate to hold the deck up.
24
20
22