Brush Pressure; Emergency Stop Button And Horn; Maximum Speed Control; Anti-Tip System - Numatic CRO 8055 Notice Originale

Machine Operation
Brush Pressure / Emergency Stop Button / Horn
Brush pressure load warning lights.
(Illuminates from left to right)
NOTE: The run-time of the machine may decrease if the load on the brushes is increased.
The CRO 8055 / 8072 is equipped with an electronic braking system.
To reset, turn emergency stop button clockwise, to restart the machine turn the key off then on again.

Maximum Speed Control

Set desired traction speed as required, depending on floor type and level of soiling.
Once the Max speed has been set using the control knob on the control panel,
fine adjustments can be made using the variable control speed pedal located on the
right side of the footplate.
!
Care must be taken to reduce speed when cornering or manoeuvring.

Anti-tip System

The CRO 8055 / 8072 is equipped with an
Anti-tip system.
The machine automatically slows down
preventing the machine from tipping over if
cornering at speed.
The buffers at the front are designed to
prevent the machine tipping in the event of
the operator turning sharply.
The buffers are designed to be replaceable
when worn.
18
www.numatic.co.uk
In an emergency, strike the emergency stop
to disable the machine.
Horn button.
!