Brush Pressure / Load Adjustment; Emergency Stop - Numatic TTB 6055/100T Mode D'emploi

Brush pressure / Load adjustment

The brush load lever is located to the right hand side of the machine.
This option is for hard to clean patches, adding extra pressure to the brushes.
24
NOTE: It is recommended this option is NOT used all the time and is for spot cleaning only.
The run-time of the machine may decrease if the load on the brushes is increased.
Waste-water Tank Fill Level Warning Light

Emergency Stop

26
Setting the Cleaning Controls
A
The brush load indicator on the control display
shows the pressure applied, when the machine
is being operated.
(A) Standard Duty
17 Kg Pressure
(Fig.24)
Machine Operation
When the waste-water tank becomes full, a red warning light will
illuminate on the operator control panel (as illustrated).
The vacuum motor will stop automatically after 5 seconds.
The waste-water tank requires emptying (see page 38).
The TTB 6055T is equipped with an electronic braking system.
Simply release the hand operated start / stop trigger and the machine will stop.
In an emergency, strike the Emergency Stop button.
The machine will be disabled.
To reset, turn Emergency Stop button clockwise (see Fig.26).
After re-setting the Emergency Stop button, to restart the machine, turn the main
control on / off key to '0' and then position '1'.
(B) Heavy Duty
30 Kg Pressure
(Fig.25)
32
25
B