Floor Tool; Abstreifers - Numatic TTV678-300 Mode D'emploi

ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY MAINTENANCE
!
The floor-tool
To clean the floor-tool, remove securing-pin and pull-free from the holder (see fig.42).
Rinse the floor-tool assembly with clean water and refit.
Periodically the floor-tool blades should be examined and checked for wear and damage.
The blade removal is easy. Simply start by removing the four retaining pins (see fig.43), turn the floor-tool over
and separate the blade carrier from the body (see fig.44).
Peel away the blades from their locating lugs (see fig.45) and examine or renew as required.
Replacement is a reversal of the removal process.
Floor-tool overview (fig.46).
1. Floor-tool main body
2. Rear blade
3. Blade carrier
4. Front blade (slotted)
5. Retaining pins x 4
32
Fig.42
1
Fig.44
2
3
4
Fig.45
USING THE MASTER CONTROL ON/OFF KEY.
REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION.
5
235670 02/12 (A09)
Fig.43
Fig.46
!