Setting The Width; Filling The Clean-Water Tank; Breite Einstellen; Frischwassertanks Füllen - Numatic TTV678-300 Mode D'emploi

Table des Matières

Publicité

Setting the width adjustment
First push the side pod in (see fig.18), then pull the side pod adjustment lever
and set it to one of the three width-settings (see fig.19) Repeat the
operation on both sides.
1
Fig.19
650mm
Filling the clean water tank
The TTV-678 is equipped with a large capacity 110 litre clean-water tank allowing, for large areas to be covered
in a single fill.
2
To fill the clean-water tank, lift the cover flap (fig.20) to expose the filler cap.
Unscrew the filler cap (fig.21) and fill the tank using a hose (fig.22) or preferred method.
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from
debris.
Fig.23
14
Fig.20
Fill-level indicator
The water level in the clean water tank can be measured using
the scale on the rear of the machine (fig.23).
235670 02/12 (A09)
750mm
Fig.21
Fig.18
850mm
Fig.22

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ttv678-400t

Table des Matières