Brush Pressure; Emergency Stop Button And Horn; Anti-Tip System - Numatic CRO 8055/100T Notice Originale

Brush Pressure

28
Note: The run-time of the machine may decrease if the load on the brushes is increased

Emergency Stop Button and Horn

The CRO 8055 is equipped with an electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop button and the machine will be disabled.
To reset, turn emergency stop button clockwise (Fig.29).
After resetting the emergency stop button, to restart the machine,
turn the ignition key to the 'Off' then the 'On' position again.
30

Anti-tip System

!
31
The buffers are designed to be replaceable
when worn.
Machine Operation
The machine is equipped with a brush-pressure load warning system (Fig.28). As the load
on the Brush increases the LEDs on the Load Indicator will illuminate from left to right.
The horn is located on the right-hand side of the operator control panel (Fig.30).
Care must be taken to reduce speed when cornering or manoeuvring
The CRO 8055 is equipped with an Anti-tip system. If the operator attempts to turn a
corner when the machine is going at speed,
the machine will automatically slow down preventing the machine from tipping over.
Additionally the buffers at the front of the machine are designed to prevent the machine
tipping in the event of the operator turning sharply (Fig.31).
26
29
!