Pacojet Junior Mode D'emploi page 24

click
1
2
Secure the combination of the spray guard (8) and
pacotizing blade (9) to the pacotizing shaft with blade
holder (2). The blade holder must engage and hold
the pacotizing blade and spray guard securely.
You will hear a clicking noise when the pacotizing
blade is secured properly.
4.
Note
Damage to the device and accessories due
to food not being fully frozen!
• The food preparation must not have started
to thaw.
• Make sure that the food preparation in the
beaker has frozen evenly at between -18 °C and
-23 °C for at least 24 hours and sticks firmly to
the pacotizing beaker.
Remove the pacotizing beaker (10) containing the
frozen food preparation from the freezer.
Remove the beaker lid (11).
Insert the pacotizing beaker into the protective
beaker (12).
5.
Note
Damage to property caused by incorrect
use of the protective / pacotizing beakers!
• Never attach the protective beaker (12) without
first inserting the pacotizing beaker (10).
Attach the protective beaker (12) with the pacotizing
beaker (10) to the Pacojet Junior.
To do this, slide the upright protective beaker with
pacotizing beaker upwards into the rounded mold on
the base to center it
Start this step by making sure that the handle is
pointing to the right in the starting position and that
the top of the pacotizing beaker is flat on the device.
Turn the protective beaker from right to left
approximately 90° to the left until the stop in the
holder ( ).
2
The handle will point forwards when the protective
beaker is attached correctly.
.
1
19
EN