Unpack the Pacojet Junior. Remove the packaging material, adhesive strips, and protective
films from the device.
Store the packaging material (cardboard box and styrofoam inserts)
for transport, storage, and possible returns (e.g., in the event of
maintenance).
6.2
Checking the scope of delivery
Check the contents of the packaging to make sure all parts are complete and in a good
condition (see Chapter "4. Scope of delivery" on page 10).
If you notice any defects or missing accessories, please contact your PACOJET sales point or
your official PACOJET service partner immediately (see Chapter "15. Customer service" on
page 34).
6.3
Setting up the device / underlying conditions for setup
Note
Damage due to overheating!
A lack of ventilation may cause the device to overheat due to poor ventilation
and air circulation.
• Cool air must be able to be sucked into the back of the device and blown out of the
bottom of the device without hindrance.
• The air vents must never be obstructed or blocked.
•
Position the device on a safe, stable, flat, and dry surface.
•
Arrange the mains power cable so that it cannot be damaged by edges or hot surfaces.
•
The mains switch (5) must remain freely accessible
Never operate the device under the following conditions:
•
In direct proximity to a heat source
•
On a vibrating base
•
On a hot surface
•
Directly next to a fan or air conditioning unit
•
Directly next to an outlet for moist or greasy vapors
•
Directly next to an outlet for warm or hot air
•
Directly next to water points and devices that are cleaned with a water hose or steam jet
•
Without the rubber feet
•
When the gap between the back of the device and other objects is < 10
Make sure there is enough room for movement in the area around the Pacojet Junior. This is
the only way to guarantee safe operation of the device.
Failure to observe the list of setup conditions may result in malfunctions and damage to the
Pacojet Junior.
cm.
15
EN