Defects - Pacojet Junior Mode D'emploi

9.

Defects

If the measures described below do not successfully rectify the problem or if your issue is not
described in the list below, please contact your official PACOJET service partner (see Chapter
"15. Customer service" on page 34).
Problem
The Pacojet Junior stops
even though the required
quantity has not been
processed, either in full or
in part.
The portion quantity
indicator (18) shows "EE".
The Pacojet is not
generating any positive
pressure during the
pacotizing process.
The pacotizing blade (9)
does not engage with the
blade holder (2) anymore.
Cause
The device has overloaded.
(Overloading normally occurs
if a food preparation recipe
cannot be processed.)
The surface of the spray
guard (8) is not flat. Because
this component makes sure
that the processing system
is sealed, the surface of
the material on the seal's
lips must be clean and
undamaged.
The pacotizing blade is held
by the blade holder when the
motor is stationary. The blade
may be rejected if the blade
holder or pacotizing blade is
dirty.
Measure
Switch off the device at the
mains switch (5) and then
switch it back on again after
approx. 5 seconds.
If the portion quantity
indicator no longer shows
"EE", you can start processing
further beakers straight away.
If the portion quantity
indicator still shows "EE"
when the device is switched
back on, the mechanical
overload protection
mechanism has been
activated. Contact your official
PACOJET service partner.
Check the spray guard for any
contamination or damage.
Clean any dirt off the spray
guard.
If the device still fails to build
up any pressure, contact
your official PACOJET service
partner.
Clean the connection piece
and the hole in the pacotizing
blade.
If the pacotizing blade still
does not engage with the
beveled magnetic blade
holder, contact your official
PACOJET service partner.
31
EN