Connecting The Device To The Mains; Switching The Device On And Off; Switching On The Device; Standby Mode - Pacojet Junior Mode D'emploi

EN
6.4 Connecting the device to the mains
The connecting cable and mains plug (6) are located on the right-hand side of the device.
When using a extension lead, make sure it is earthed in accordance with the relevant
regulations.
Note
Damage to property caused by incorrect electrical connections!
Failure to observe the necessary specifications for electrical connections may
result in damage to the device.
• The Pacojet Junior must always be operated in accordance with the specifications
for electrical performance listed on the type plate (see also Chapter "10. Technical
specifications" on page 32).
• The mains voltage must never deviate from the specified value by more than 10%.
6.5 Switching the device on and off
6.5.1

Switching on the device

6.5.2

Standby mode

If no action is taken within 5 minutes, the device switches to "standby mode". When the
"START KEY" (21) is operated, the device switches back to "operating mode".
6.5.3

Switching off the device

Switch off the device by moving the mains switch (5) to position "0".
The POWER DISPLAY (20) goes out.
Warning
Risk of severe injuries caused by defective electrical
components!
• Always check the device for damage before use.
• Never use the device if it is damaged.
• Always have the device repaired by an official service partner.
Switch on the device by moving the mains switch (5) to
position "I". The device is in "operating mode".
The Pacojet Junior can now be programmed.
16