Russell Hobbs 21480-56 Manuel page 4

• As it's a combination of a blender and a heater, you can also use it to blend, to make smoothies, to
crush ice, and even boil potatoes.
ASSEMBLY
IMPORTANT: If either the lid or jug is incorrectly fitted the unit will not work.
1. Fit the jug on top of the motor unit, and press down, till it clicks into place (it will only fit one way).
2. To fit the lid, hook the front of the lid over the jug spout (Fig. A).
3. Lower the lid and press down on the back of the lid until the lid lock clicks outwards (fig. B).
4. Fit the cup into the hole in the lid. The cup is marked at 30ml and 60ml. Filled to the rim, it holds
130ml.
DISASSEMBLY
1. Lift the cup out of the lid.
2. Press the lid lock, and lift the lid off the jug.
3. Squeeze the jug lock into the handle, and lift the jug off the motor unit.
Removing the jug or the lid will cut power from the motor and heater, and the 2 light will go out.
Replacing them will reconnect the power, but you'll need to restart the motor and/or heater.
Don't run the motor without the cup, ingredients may be ejected through the hole.
FILLING
1. Normally, you should switch the appliance to standby (2), remove the jug from the motor unit, and
remove the lid from the jug, before filling the jug.
2. There are two MAX marks inside the jug. MAX, at 1.75 litres, for cold ingredients, and SOUP MAX, at
1.4 litres, for hot ingredients, like soup or sauce, where the ingredients will expand, when heated
3. To add ingredients while the appliance is working, remove the cup, add the ingredients via the hole
in the lid, then replace the cup.
POWER UP
1. Put the plug into the power socket (switch the socket on, if it's switchable).
The appliance beeps. The 2 light flashes. Press the 2 button until the light stays on.
2.
BROWNING
1. If you want to brown meat and/or vegetables before making soup, put 30ml oil or a large knob of
butter in the bottom of the jug, add the meat/vegetables, replace the lid and cup.
Press L, cook for 1 minute, then press and release Y, to stir things up a bit.
2.
3. Remove the cup, have a look, then replace the cup.
4. Repeat till the browning looks right, add the rest of the ingredients and start the program.
CHOOSE YOUR PROGRAM
1. Press the button that corresponds with the program you want. The appliance will beep and the light
in the button will come on.
2. To cancel the program, press the button again. The appliance will beep and the light in the button
will go out.
standby
2
low speed
P
high speed
^
manual operation
Y
ice crush
I
motor off, heater off
blends for 2 minutes – for general blending
blends for 2 minutes – for smoothies, milkshakes, etc.
press Y to run the motor, release it to stop
blends for 10 sessions of 3 seconds on/3 second off
4