Bosch rexroth APAS CT-H Manuel D'utilisation page 35

3.3 Connection cable
In addition to the X1 connection on the handle according to
fi g. 2, the electrical interfaces are available on the connection cable
according to fi g. 3.
Fig. 3: Schematic representation of the connection cable with connection points
PCB:X1 Connection for I/O signals in the direction of the control
X6 Connection for I/O signals of the SSKU
X7 Crocodile clip for low-voltage external ground
X8 Connection for handle
L1 Connection cable for low-voltage ground
L2 Connection cable for handle
L3 Connection cable for I/O signals of the SSKU
The connection cable acts as an intermediate plug for the I/O signals
between the SSKU and the control. The pin assignment of PCB:X1
is identical to the pin assignment X3 of the SSKU with the following
exceptions: CH1 LS (pin 1), CH1 Ini_Skin (+) (pin 3), CH2 LS (pin 8) and
CH2 Ini Skin (+) (pin 10) are not available at PCB:X1 and are unassigned.
3 842 562 818, edition 08.2021, Bosch Rexroth AG