Bosch rexroth APAS CT-H Manuel D'utilisation page 30

8/22 APAS test device CT-H | Safety instructions
Bosch Rexroth AG, edition 08.2021, 3 842 562 818
• Programming and editing programs and automatic sequences.
• Remedy faults at the robot system and maintain and service
the robot systems.
For the work of the system integrator, the mandatory training
courses at the BCI Training Center according to table 5 are required.
Table 5: Mandatory training courses for the system integrator at the
BCI Training Center
Designation
Basic course "Safe handling"
Advanced course "Sensor skin maintenance"
Advanced course "Preparation of work schedules"
Advanced course "Integration into projects"
You can fi nd an overview of the current training courses and training
content online at: https://www.bosch-apas.com/downloads/
2.5 General safety instructions
Risk of injury due to improper use of the machine to be tested,
non-observance of safety instructions in the documentation of the
machine to be tested or insuffi cient effectiveness of the protective
equipment.
 The assembly and operating manual for the machine on which the
APAS test device is used must be carefully read and adhered to.
 Block off the danger zone of the machine while using the
APAS test device CT-H.
 Only enter the danger area to perform checks when the robot system
is at a safe stop.
Risk of injury and damage due to foreign bodies in the working area of
the machine or due to foreign bodies in the control cabinet
 The APAS test device must be removed from the machine to be
tested immediately after use and the machine must be reset to the
TARGET state.
 The APAS test device must not remain in the control cabinet or
working area of the machine.
WARNING
WARNING
Reference code
[BCI-SP-AP031]
[BCI-SP-AP015]
[BCI-SP-AP038]
[BCI-SP-AP037]