Bosch rexroth APAS CT-H Manuel D'utilisation page 31

Safety instructions | APAS test device CT-H
2.6 Product-specifi c safety instructions
Risk of death due to electric shock
 The APAS test device may only be commissioned, operated and
decommissioned by authorized specialist personnel in accordance
with the instructions in chapter 5 "Commissioning, operation and
decommissioning".
 Only the original accessories supplied may be used for connection.
 The ground connection supplied to the APAS test device must be low
in external voltage.
 The APAS test device must not be used to extend a protective
conductor system.
Risk of injury and damage due to malfunction of the machine as
a result of a fault in the connected APAS test device or as a result of
electromagnetic incompatibility
 The APAS test device may only be used with the original accessories
supplied.
 The APAS test device may only be commissioned, operated and
decommissioned by authorized specialist personnel in accordance
with chapter 5.
 The APAS test device must be removed from the machine to be
tested immediately after use and the machine must be reset to the
TARGET state.
 Observe the specifi cations according to chapter 6 "Maintenance and
inspection".
 Operate the APAS test device only under the ambient conditions
specifi ed in chapter 3.4.
Risk of injury and damage due to the APAS test device CT-H falling or
being thrown around
 The machine is operated in manual mode or at reduced,
safely monitored collaboration speed while the APAS test device CT-H
is in use.
 For stationary use, the APAS test device is placed fi rmly on a level
surface with a suitable stand or comparable device.
 Block off the danger zone of the machine while using the
APAS test device CT-H.
 Wear appropriate personal protective equipment such as protective
goggles and safety shoes.
DANGER
WARNING
CAUTION
3 842 562 818, edition 08.2021, Bosch Rexroth AG
9/22