Masimo SafetyNet Alert Manuel De L'utilisateur page 43

Displayed Messages
"Request Sent"
"A request has been sent to
your Emergency Contact.
Follow up with your
Emergency Contact to make
sure they accept."
"Email Sent!"
"Please check your email to
confirm"
"Device in use"
"Cannot modify a device that
is actively monitoring. Please
end your monitoring session
and try again."
"Remove this emergency
contact?"
"Remove selected
emergency contacts?"
"Remove this device?"
"Save Changes?"
"Your unsaved changes will
be lost. Save changes before
closing?"
"Your Home Medical Hub is
paired"
"No Home Medical Hub
added"
Potential Causes
Displayed after successfully
sending an emergency
contact invitation
Resend button was pressed to
request a new email
verification link.
When an attempt was made
to to modify or delete the
Home Medical Hub during
active monitoring.
Displayed when removing
one or more emergency
contacts.
Displayed when attempting
to remove Home Medical
Hub
Displayed when attempting
to update profile information.
The Home Medical Hub has
paired successfully.
Home Medical Hub is not
connected to the app.
Next Steps
For information only, no action is required.
For information only, no action is required.
End the monitoring session before attempting
to modify the device.
Select Remove to confirm or Cancel to cancel
the operation.
Select Remove to confirm or Cancel to cancel
the operation.
Select Yes to confirm or No to not save
changes.
For information only, no action is required.
Follow instruction on the app or this manual to
complete set up. See
Setup
on page 21.
41
Home Medical Hub