Wheel Data Entry With Automatic Sensors - SICE S 65 Manuel D'instructions

To select the icon desired, use the Arrow keys until the icon desired is highlighted.
Select by pressing the Enter button
The functions of every icon in the main menu are listed below:
1. balancing programs icon
; if called up, it groups the functions relating to the balancing types.
2. the utility and configuration programmes icon
ration programmes of the machine;
3. the highest accuracy icon
possible accuracy ("Gr x1" or "Oz 1/10");
4. the help icon
error message is displayed, the first piece of information displayed concerns the type
of errors that may occur. The instructions called up by this icon integrate (but do not
replace) this User Manual.
By default the icons relating to points 3 and 4 are those described above but can be
replaced with more frequently used ones (refer to the "Preferred programme configura-
tion" section).
WHEEL DATA ENTRY WITH AUTOMATIC
To enter the distance, diameter and width values automatically, proceed as follows:
- bring the automatic internal measuring arm (1, Fig. 8) into contact with the inner side of
the rim as shown in Fig. 10/10a, and simultaneously bring the automatic external measur-
ing arm (2, Fig. 8) into contact with the outer side Fig. 11.
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arms in contact with the rim until the machine has acquired the values. Geo-
metric data (distance, diameter and width) are displayed.
- Check the values measured and then return the arm to the rest position.
- If an incorrect value has been acquired during the measurement phase, move the arms
to the rest position and then repeat the operation.
Measurements can also be taken by moving one measuring arm at a time. In this case,
80
.
allows balancing results to be displayed with best
displays the information relating to the current screen. If an
SENSORS
groups all utility and configu-
User manual S 65