Configuration Programmes - SICE S 65 Manuel D'instructions

- change the value of the distance dis-
played by entering that indicated on
the internal sensor (A, Fig.20) using
the keypad;
press the exit button
-
terminate the manual data setting.

CONFIGURATION PROGRAMMES

The Configuration programmes are those functions that are intended for customising the
machine's operation and are normally executed when the machine is installed.
The list of the configuration programmes can be displayed as follows:
- Select the utility and configuration programmes icon
Select the configuration programmes icon
-
Automatic Position Search (RPA) Configuration
Enables/disables the automatic positioning of the wheel at the end of the spin. After the
list of the setting programmes is displayed, proceed as follows:
- Select the Automatic position search configuration icon
The following icons are displayed:
RPA OFF; disables the automatic position search procedure.
RPA ON; enables the automatic position search procedure.
- Press the Enter button
User manual S 65
to
.
to select the icon desired.
20
;
.
103
UK