Static Balancing; Utility Programmes - SICE S 65 Manuel D'instructions

- apply two new counterweights in the positions indicated.
The weight division operations can be performed on both balancing sides.
A wheel can be balanced using a single counterweight on one of its two sides or in the
centre of the well. in this case, the wheel is balanced statically. However, there is still
the risk of dynamic unbalance, which becomes more significant as the width of the wheel
increases.
Proceed as follows to balance motorcycle or car wheels statically:
Select the balancing programmes icon
-
select the Static balancing programme icon
-
The displayed image now shows only one position search.
- Apply the balancing weight in the 12 o'clock position on either the outer or inner side,
or at the centre of the rim well, indifferently. If applied in the well, the weight is applied
on a diameter smaller than the rated diameter of the rim. A value of 2 or 3 inches less
than the rated value must therefore be entered when the diameter is set in order to
obtain correct results.
Best results can be achieved if the weight is divided into two parts to be applied on the
two sides of the rim.
The Utility programmes are all the functions of the machine that are useful for its opera-
tion but are not strictly connected to its normal operation.
Select the Utility and configuration programmes icon to display the list (menu) of the

utility programmes

This wheel balancer allows three operators to work at the same time thanks to three dif-
ferent working environments.
- Select the Working environments icon
- The following icons are displayed:
94

Static balancing

UTILITY PROGRAMMES
.
Working environment programme
;
.
to call up a different working environment.
User manual S 65