Installation - SICE S 65 Manuel D'instructions

The machine may be moved after
installation by inserting the forks of
a lift truck under the machine itself,
with centre line between the forks
approximately aligned with the centre
line of the body (Fig. 2).
WARNING
Always unplug the power supply ca-
ble from the socket before moving
the machine.
WARNING
Never apply force to the wheel spin
shaft when moving the machine.
WARNING
Take the utmost care when unpacking, assembling, lifting and setting up the machine
as indicated below.
Failure to observe these instructions can damage the machine and compromise the
operator's safety.
Remove the original packaging materials after positioning them as indicated on the
packaging and keep them intact so the machine can be safely shipped at a later date
if necessary.
WARNING
The place where the machine is to be installed must conform to applicable safety at
work regulations.
In particular, the machine must only be installed and used in protected environments
where there is no risk of anything dripping onto it.
IMPORTANT: for the correct and safe operation of the machine, the lighting level in the
place of use should be at least 300 lux.
The floor must be strong enough to support a load equal to the weight of the equipment
plus the maximum load allowed. The support base on the floor and the envisaged fixing
means must also be taken into account.
Environmental operating conditions must comply with the following requirements:
- relative humidity ranging from 30% to 80% (without condensation);
66

INSTALLATION

2
User manual S 65