SICE S 65 Manuel D'instructions page 88

This programme divides the outer weight Pe into two weights, P1 and P2, located in any
position chosen by the operator.
The only condition is that the two weights and the original outer weight Pe must be within
an angle of 120°, as shown in Fig. 16.
Figure 16. Conditions for using the Hidden Weights programme
The Hidden Weight programme is used on alloy rims, only and exclusively in conjunc-
tion with the ALU 1P/ALU 2P programme:
- when the outer weight would rather be hidden behind two spokes for aesthetic rea-
sons.
To use this programme, proceed as follows:
1. Beforehand, select between one of the programmes, ALU 1P, ALU 2P by selecting the
ALU 1P Balancing programme or the ALU 2P Balancing programme icon.
The mask for measuring the unbalance on alloy rims is displayed.
2. Perform the wheel balancing procedure as described in the chapter "ALU 1P, ALU 2P
programmes", but without applying the outer weight.
3. Select the
the machine displays the message shown in Fig. 16a on the screen.
88
"HIDDEN WEIGHTS" PROGRAMME
(available on with ALU P programme)
Hidden weight icon. If the wheel is balanced on the outer side,
16
User manual S 65