SICE S 65 Manuel D'instructions page 86

In Alu 2P refer to the rim edge, since the inner weight is of the traditional clip type
(Fig.11).
Pay maximum attention when the end of the arm is being placed in an area of the rim
free of discontinuity, so that the weight can be applied in that position.
- Keep the arm in position. After two seconds the machine emits an acoustic confirmation
signal to indicate that the distance and diameter values have been acquired.
- Move the end of the automatic measuring arm in correspondence with the plane selected
for the application of the outside balancing weight (Fig. 14/14a), in the same manner as
described previously for the inner side.
- Keep the arm in position and wait for the acoustic confirmation signal.
- Return the measuring arm to the rest position.
If the measuring arm is returned to the rest position after acquiring the data relating to
only one plane or if first the outer plane data then the inner plate data are acquired, the
A 23 message is displayed and the acquired data are not considered.
- Perform a spin.
Applying balancing weights (Fig. 15)
- Select the plane where the first balancing weight is to be applied.
- Turn the wheel until the central element of the corresponding position indicator lights up.
If the weight to apply is of the traditional clip type(inner side in Alu 2P), position it at 12
o'clock. If, on the other hand, the weight to be applied is of the adhesive type and there
is a weight holder device, proceed as follows:
- Centre it inside the cavity of the weight-holder terminal of the measuring arm (Fig.15,a,b),
with the backing paper of the adhesive strip facing up. Remove the protection (Fig. 15c)
and turn the terminal so that the adhesive faces the internal surface of the rim.
- Move the sensor until the two reference lines (green in colour) coincide in the relevant
windows on the screen.
- Turn the end of the measuring arm until the weight adhesive strip is in line with the rim
surface.
- Press the key (Fig. 15d) to eject the weight and make it stick to the rim.
86
14 14a
User manual S 65