Trainer; Analog Switch Setup - Spektrum DX18 Manuel D'utilisation

Trainer

The DX18 features a programmable trainer function with 4
trainer modes. The transmitter assigns the trainer function to
Switch I. The function activates when you press the trainer
switch and select 1 of the 4 trainer modes. The 4 trainer Modes
include:
Inhibit
In Inhibit, the slave transmitter must have the same program-
ming as the master (e.g., servo reversing, travel adjust, sub-trim,
trims).
Programmable
With Programmable, you can program the transmitter to transfer
any or all channels when you activate the trainer switch. This
is ideal for beginners so the student learns control of individual
channels (aileron only for example) while the trainer maintains
control of all other channels. The slave transmitter should be
set to factory default settings with Pilot Link Slave trainer type
selected, if available.
Pilot Link Master
When Pilot Link Master is selected, the slave transmitter has
control of the stick function only (aileron, elevator, rudder and
throttle) while the master maintains control of all other chan-
nels and functions (including D/R and switch positions). This is
ideal for complex models as the master maintains control of all
secondary functions and controls all other channels.

Analog Switch Setup

Allow all sticks and pots to be used as a kick point to turn on
functions like mixes. To select the kick point: move the stick,
lever, or knob to the position desired to be the kick point; with
the roller highlight the kick point desired; and then press the
roller to set the value.
SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL
Slave
Use Slave mode when flying with the DX18 as a slave when the
master radio has activated its Pilot Link. In this case, there is
no need to match programming between the slave and master
transmitter.
DX18 Trainer Operation
1. Bind the transmitter to the model.
2. Connect the controlling trainer cord (SMP6805) to the back
of the master transmitter.
3. Make sure the slave transmitter batteries are charged.
4. Make sure the slave transmitter is powered off; the slave
transmitter receives power when you connect the trainer
cord.
5. Connect the trainer cord to the slave transmitter.
6. The slave transmitter screen will show information but will
not send a signal to the model.
7. Release the button.
EN
17