X-Plus; Using The Transmitter - Spektrum DX18 Manuel D'utilisation

EN

x-PLUS™

x-Plus Channels and Failsafe
We recommend that no failsafe should be expected or attempted
for a servo connected through the X-Plus Module. Failsafe is not
supported for servos connected to the X-Plus Module. However,
servos connected to the X-Plus Module will hold last command
in the event of a failsafe condition.
To Activate X-Plus
1. Open the Frame Rate Menu in System Setup.
2. Scrolll to X-Plus and press the scroll wheel to activate. The
X-Plus Inputs screen is now active in the Channel Assign
menu.

USING THE TRANSMITTER

SD Card
Use an SD Card and the Transfer SD Card screen in the
System Setup list to to do the following:
• Import (copy) models from another DX18 transmitter
• Export (transfer) models to another DX18 transmitter
• Update AirWare™ software in the transmitter
• Share model files among DX18 transmitters.
Remove the battery cover and put an SD card in the SD card slot
on the bottom of the transmitter with the card's label facing the
back of the transmitter.
Tip: On the System Settings Serial Number screen, you can export
your DX18 serial number to your SD card as a text file for easier
registration at community.spektrumrc.com. Use your computer's
copy and paste commands.
10
AUX6 and AUX7 channels are available on 12-channel receivers
when X-Plus is active. AUX6 and AUX7 are 2048 resolution and
22ms frame rate (12-channel receivers only).
If you select 11ms frame rate before you activate X-Plus, the
transmitter reverts to 22ms frame rate when X-Plus is active.
CAUTION:
Do NOT connect throttle or any primary
control surface to the X-Plus Module. The X-Plus chan-
nels are intended to be used for auxiliary functions only. X-Plus
channels have a resolution of 512 and variable latency from
22ms to about 88ms. When X-Plus is active, the first 10 chan-
nels default to 22ms.
Refer to www.spektrumrc.com for more information about X-
Plus options.
from Channel Assign menu
SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL