Trainer - Spektrum DX18t Manuel D'utilisation

Trainer

The DX18t features a programmable trainer function
with 4 wired trainer modes and 2 wireless trainer modes.
The transmitter assigns the trainer function to Switch I.
Wired Trainer
The 4 wired trainer modes include:
Inhibit
In Inhibit, the slave transmitter must have the same programming
as the master transmitter (e.g., servo reversing, travel adjust,
sub-trim, trims).
Programmable Master
Programmable mode enables you to program the master
transmitter to transfer any or all individual channels when you
activate the trainer switch. This mode is ideal for beginners learn-
ing to control individual channels while the master transmitter
maintains control of all other channels.
The slave transmitter should be in Inhibit mode, if available. The
Master and Slave transmitters MUST have the same programming.
Pilot Link Master
Pilot Link Master enables you to program the master transmitter
to transfer any or all individual channels when you activate the
trainer switch. Pilot Link Master is ideal for complex models,
as the master transmitter can maintain control of all secondary
functions—for example flight modes, retracts, flaps and brakes.
Secondary functions can be individually assigned to the Slave
transmitter as necessary. It is not necessary to have model
programming in the slave transmitter.
It may be necessary for the slave transmitter to be in Inhibit mode
to allow trim changes to transfer over from the master transmitter.
SPEKTRUM DX18t • TRANSMITTER INSTRUCTION MANUAL
Slave
Use Slave mode when using the DX18t as a slave transmitter
and Pilot Link is active in the master transmitter.
Wired Trainer Operation
1. Bind the master transmitter to the model.
2. Connect the trainer cord (SPM6805) to the back of the
master transmitter.
3. Make sure the master and slave transmitter battery packs
are fully charged.
4. Make sure the slave transmitter is powered off. The slave
transmitter receives power when you connect the trainer cord.
5. Connect the trainer cord to the slave transmitter.
6. The slave transmitter screen displays information but does
not send a signal to the model.
7. Press the trainer button on the master transmitter to transfer
model control from the master to the slave.
8. While moving the trainer switch between the off and on
positions, watch for movement on the control surfaces.
Adjust the trims as necessary before flying.
9. Release the trainer button and the master transmitter
regains control of the model.
Master Override
The Master Override feature enables the instructor to immediately
regain control of the model by moving the control sticks. After you
activate Master Override, the slave transmitter cannot control the
model until you reset the trainer switch. To reset the trainer switch:
1. Move the trainer switch to the OFF position.
2. Move the trainer switch to the ON position to activate
the slave transmitter.
Wireless Trainer
Wireless Trainer works just like the Wired Trainer, without the wire.
Select Wireless Trainer to bind a DSM2 or DSMX slave transmit-
ter to the master transmitter. With this option, when the master
presses the trainer button or switch, control is given to the cur-
rently bound slave transmitter. After binding, the slave transmitter
will remain bound to the model in the master transmitter.
Inhibit
In Inhibit, the wireless trainer function will be inhibited
and will not function.
CAUTION: Select Inhibit in the Trainer menu when
you are not using the wireless trainer function. Failure to
select Inhibit may result in loss of control of the aircraft.
EN
19