System Settings; User Name; Contrast; Backlight - Spektrum DX18 Manuel D'utilisation

EN

SYSTEM SETTINGS

Use the System Setting screen to establish the overall transmitter setting that will apply to ALL model memories. These settings
include: User Name, Contrast, Mode, Region and Language. When models are imported from an SD card, the system settings in the
transmitter will remain.

User Name

User Name allows the identification of the owner to be
programmed into the transmitter. The user name appears during
the startup process at the lower left corner of the startup screen.
To Program a User Name
In the Systems Settings screen, rotate the roller to highlight User
Name then press.
Highlight the desired character position then press the roller to
access that position. Rotate the roller to change to the desired

Contrast

In the Systems Settings screen, rotate the roller to highlight
Contrast then press.

Backlight

Press the scroll wheel to turn the backlight on. The Backlight
intensity can be adjusted from 10% to 100% in 10%
increments.

Mode

The Stick Mode can be selected from 2 to 4 or 1 to 3. Mode
changes that move throttle control between control sticks
require a change to the gimbals, which must be performed by an
authorized service center.
Set up your transmitter to the Mode you desire using the
System Settings Screen. Always save and power off and on the
transmitter to fully configure the transmitter in the desired Mode.

Battery Alarm

This screen allows you to change the battery type and low alarm
settings.
• An alarm will sound when the battery reaches the low volt-
age limit (4.3V for NiMH, 6.4V for LiPo).

Selecting a Language

In the Systems Settings screen, rotate the roller to highlight
Language then press the roller to select the Language function.
Two Languages are available, English and German. Other
languages may become available through AirWare updates.
Refer to www.spektrumrc.com for current support.
18
character. Press to accept.
Repeat the process until the name is complete. Note that the
User Name displays on the lower left of the startup screen.
Rotate the roller to adjust the contrast (from 1 to 20) noting it on
screen. Press to accept.
If you program the backlight to be off, the backlight will
momentarily show when you power on your transmitter.
Some modes require mechanical change to the gimbals, which
can only be accomplished by an authorized Spektrum service
center. If desired, contact your nearest service center.
After selecting the mode desired, press NEXT to access the
Calibration screen, and calibrate the transmitter. Power off to
complete the change.
CAUTION: Never change the low voltage limit for LiPo
batteries from 6.4V. Doing so could over-discharge the
battery and damage both battery and transmitter.
Rotate the roller to select the desired Language. When the
desired Language is selected, press the roller to accept that
Language. Names you input will not be affected by language
change.
SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL