Wireless Trainer; Range Test - Spektrum SPMR1010 Manuel D'utilisation

Wireless Trainer

The DXS transmitter is capable of operating as the Instructor transmitter
for a training situation. A remote receiver (SPM9747 optional, not included)
is required to add this function. When a student transmitter is bound to the
(optional) remote receiver inside the DXS, pressing and holding the A button
gives the student control over the first four channels.
Remote Receiver Installation:
1. Open the battery door
2. Connect the remote receiver cable
to the wireless trainer port.
3. Install the remote receiver in the
cavity behind the battery door with
double sided tape.

Range Test

1. Power on the transmitter for at least five seconds with the throttle stick and trim low.
2. Press and hold switch A (Bind button) and toggle switch F four times within 10
seconds. The transmitter LEDs will flash orange and the alarm will sound. The
system is in range check mode. Do not let go of the bind button until you are
finished with the range check.
IMPORTANT: You must hold the BIND/Panic button during the entire range check
process. Releasing the button will exit the range check mode.
Binding the Student Transmitter:
1. Press and hold the bind button on
the remote receiver.
2. Power the DXS ON, the orange
LED on the remote receiver will
flash indicating it is in bind mode.
Release the bind button.
3. Put the student transmitter into
Bind mode. The orange LED on the
remote receiver will remain lit when
it is bound to the student transmitter.
4. Replace the battery door after
binding the student transmitter.
EN
11