Binding - Spektrum DX18 Manuel D'utilisation

EN

BINDING

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific trans-
mitter. The DX18 and AR9020 are pre-bound at the factory. You will need to rebind after the model programming is initially set up to
fully program the model's failsafe positions.
Binding Using the Receiver and Receiver Battery
1.
1.
4.
HOLD BUTTON WHILE POWERING ON
4.
HOLD BUTTON WHILE POWERING ON
Mode 2 Shown
Mode 2 Shown
1. Lower throttle to the lowest position and make sure the
transmitter is powered off.
2. Insert the bind plug into the BIND/DATA port.
3. Insert the receiver battery into any open port. The receiver's
LED will flash when the receiver is ready to bind.
Binding Using the Receiver and ESC
1.
1.
5.
HOLD BUTTON WHILE POWERING ON
5.
HOLD BUTTON WHILE POWERING ON
Mode 2 Shown
Mode 2 Shown
1. Lower throttle to the lowest position and make sure the
transmitter is powered off.
2. Insert the bind plug into the BIND/DATA port.
3. Insert the ESC plug into the THRO port.
4. Connect battery to ESC and turn on ESC switch, if available.
The receiver's LED will rapidly flash when the receiver is
ready to bind.
CAUTION:
When using the DX18 with parkflyer only use such receivers in parkflyer-type aircraft. (small electric airplanes
or mini and micro helicopters). Flying receivers designed for park flyers in larger aircraft could cause loss of connection.
8
2.
2.
5.
5.
2.
2. 3.
6.
6. 7.
3.
3.
6.
6.
4. While pressing the Bind button, power on the transmitter.
5. Release the Bind button after the receiver has stopped flash-
ing rapidly, once the receiver's LED stays illuminated; this
indicates the receiver is bound to the transmitter. The screen
also provides binding information.
6. Remove the bind plug from the receiver.
3.
4.
4.
7.
5. While pressing the Bind button, power on the transmitter.
6. Release the Bind button after the receiver has stopped flash-
ing rapidly, once the receiver's LED stays illuminated; this
indicates the receiver is bound to the transmitter. The screen
also provides binding information.
7. Remove the bind plug from the receiver.
SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL