Navigation; Main Screen - Spektrum DX18 Manuel D'utilisation

NAVIGATION

• Use the roller, Back and Clear buttons near the LCD screen
for DX18 programming.
• Turn or press the roller to move through, select or change
screen content.
• Use the Back button to go to the previous screen (for
example, to go from the Mixing Screen to the Function List).
• Use the Clear button to change a selected value on a screen
to its default setting (Some values do not have a default set-
ting. For example, there is no default alarm type in the Timer
Screen).
• While the transmitter is powered on, go to the Model Select
screen by pressing the Clear and Back buttons at the same
time. This is Direct Model Access, and will let you go to the
Model Select Screen without powering off and on.
• Press and hold the roller while powering on the transmitter
to show the System Setup list.
• No radio transmission occurs when a System Setup screen
is displayed, preventing accidental damage to linkages and
servos during changes to programming.
• Powering on the transmitter without touching any controls
will show the Main Screen and the active model memory.
Press the roller while on the Main Screen to show the Func-
tion List.
Tip: The tick mark below shows the current switch position.
Rolling and clicking the roller turns the selected box black, indi-
cating that the value or condition will act on that position.

Main Screen

Model Memory
A
B Model Name
C Transmitter Battery Charge Level
Digital Battery Voltage
D (an alarm sounds and the screen flashes when battery charge gets
down to 4.3V when using an NiMH battery or 6.4V for a LiPo battery.)
E Model Type
Elevator Trim (Modes 2 and 4)
F
Throttle Trim (Modes 1 and 3)
Aileron Trim (Modes 1 and 2)
G
Rudder Trim (Modes 3 and 4)
H Model Memory Timer
Rudder Trim (Modes 1 and 2)
I
Aileron Trim (Modes 3 and 4)
Throttle Trim (Mode 2 and 4)
J
Elevator Trim (Mode 1 and 3)
K Timer
SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL
Function
Also displays R Trim values when the Right
Trim button is pressed
Also displays L Trim values when the Left
Trim button is pressed
• When you want to change a value in a screen for a particu-
lar control position, move the control to the desired position
to highlight the value you want to change, such as 0/1/2,
up/down or left/right.
• There are some screens where the CLEAR and BACK but-
tons do nothing. For example, BACK does nothing on the
Main Screen while CLEAR resets the Timer. These buttons
allow you to quickly move through most screens and to re-
turn some data choices to a default setting. If you would like
to assign this level of control to other buttons or to disable
these buttons entirely, please go to the CLEAR/BACK setup
option on the System Menu. However, if you assign BACK to
the same control as Throttle Cut, use of Throttle Cut will not
show on the transmitter screen.
Press Turn
Press Turn
Enter, Choose Move between
or Exit options or change
value in an option
A B
K
J
I
Press
Hold
Hold for 3
seconds and
release to move to
the Main Screen
D
C
E
H
G
EN
F
11