Chapter 2 Acro (Airplane); Recommended Servo Connections - Spektrum DX18 Manuel D'utilisation

Masquer les pouces Voir aussi pour DX18:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CHAPTER 2 ACRO (Airplane)

NOTICE: Refer to your airplane manual for recommended control throws.
CAUTION:
Always do a Control Test of your model with the transmitter after programming to make
sure your model responds as desired.
Aircraft Type
Use the Aircraft Type Screen to select wing and tail types to
match your airplane model. Diagrams and setup names show on
the transmitter screen to show the available setups.
Refer to www.spektrumrc.com for more information about new
DX18 firmware updates to support these options.
Wing
Normal
Flaperon*
Dual Aileron
Flaperon*
1 Aileron 1 Flap*
1 Aileron 2 Flaps*
2 Ailerons 1 Flap*
2 Ailerons 2 Flaps*
Elevon
Elevon B
4 Aileron
Tail
Normal
V-Tail A**
V-Tail B**
Dual Elevator
Dual Rudder
Dual Rudder/Elevator
NEXT screen
Gyro 1
Gyro 2
Pitch Curve
Servo Control
For a delta wing or elevon wing setting, check the control throw
directions.
Begin by checking the aileron direction. With right aileron stick
movement, the right elevon should move up and the left elevon
should move down.
If the right elevon moves in the incorrect direction, reverse the
channel in the transmitter that the right elevon is plugged into.
If the left elevon moves in the incorrect direction, reverse that
channel in the transmitter.
SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL

Recommended Servo Connections

Recommended Servo Connections
*Selection of multiple ailerons activates the Differential menu option.
Dual Aileron Wing Type Connection
Dual Aileron Wing Type Connection
**Selection of either of these activates the V-Tail Differential menu option
Not all of these may be activated at the same time. Activation
of a Gyro activates the Gyro menu option for your airplane and
A
B
activation of Pitch Curve activates the Pitch Curve menu option.
A
B
When Pitch Curve is active, only 1 gyro will be available. Select
wing and tail types before doing other programming such as
Servo Setup (Travel, Sub-Trim and Reverse), D/R and Expo, Flap
System, Differential or Mixing.
V-Tail and Elevon Wing selections may require attention to Servo
Setup Reverse to make the model respond correctly to controls.
Recommended Servo Connections
Dual Aileron Wing
Dual Aileron Wing
Type Connection
Type Connection
A
B
A
B
Elevon
Elevon
Wing Type
Wing Type
Connection
Connection
E
F
F
E
Once both elevons move in the correct direction with aileron
stick movement, check the elevator direction. With up elevator,
both elevons should go up and vice versa.
If the elevator direction is incorrect, switch the servo channels in
the receiver.
The possible servo reversing options for a delta wing model are
below:
Aileron
Normal
Normal
Reverse
Reverse
V-Tail Type
V-Tail Type
Connection
Connection
C
D
C
D
V-Tail Type
V-Tail Type
Connection
Connection
C
D
C
D
A AUX1 servo port (left aileron)
B AILE servo port (right aileron)
C ELEV servo port (left V-tail)
D RUDD servo port (right V-tail)
E AILE servo port (left aileron)
F ELEV servo port (right aileron)
Elevator
Reverse
Normal
Reverse
Normal
EN
Elevon
Elevon
Wing Typ
Wing Type
Connecti
Connectio
E
E
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Spm dx18Spm18000euSpm180001eu

Table des Matières