Motorising An Existing Gate; Product Description; Area Of Application; Contents Of The Standard Kit - SOMFY ELIXO 500 3S io Manuel D'installation

Power supply
• In order to operate, the motor must be supplied with 230 V 50 Hz. The electric line should:
• solely be used for the motor,
• have a minimum cross section of 1.5 mm²,
• be fitted with an approved all-pole switch with contact openings of at least 3.5 mm, fitted with a protection device (fuse or circuit breaker with a 16 A
rating) and a differential device (30 mA),
• be installed in accordance with the current electrical safety standards,
• be fitted with a lightning conductor (in compliance with standard NF C 61740, maximum residual voltage 2 kV),
• Check whether the earthing system is performed correctly: connect all the metal parts of the assembly and all the components of the installation equipped
with earth terminals.
• After installation, ensure that the mechanism is correctly adjusted and that the protection system and any manual release mechanism operate correctly.
safety devices
• The selected safety accessories for the installation must comply with the current standards and regulations in force in the country in which the product is
being installed. The use of any safety components not approved by Somfy remains the sole responsibility of the installer.
• Install all the safety devices (photoelectric cells, safety edges, etc.) required to protect the zone from the danger of crushing, movement force and cutting
according to the applicable directives and technical standards.
• In accordance with standard EN 12453 governing the safe use of motorised gates and doors, the use of the TAHOMA control box to automatically control a
garage door or gate not visible to the user requires the installation of a photoelectric cell type safety device with autotest on the automatic control system.
maintenance
• Regularly check the condition of the gate. Gates in poor condition must be repaired, reinforced or even replaced. Check that the various motorisation
component's screws and fittings are correctly tightened.
• Before carrying out work on the installation, switch off the power supply.
• Use only original parts for any maintenance or repair work.

motorising an existing gate

Carry out a stress test with a measuring device which conforms to the requirements set out on in clause 5.1.1 of standard EN 12445.

ProduCt dEsCriPtioN

area of application

Sliding gates up to 500 kg and carrying out 30 manoeuvres per day.
To ensure the safety of all equipment and persons, respect the information given in the table:
For a gate weighing ... use ...
0 to 300 kg a passive rubber block on the end of the gate
300 to 500 kg a passive rubber block on the end of the gate
If using a different rubber block to those listed above, ensure that the installation conforms with current regulations.

Contents of the standard kit

1 Elixo 24 V Motor
2 KEYGO io remote control
3 Offset io aerial
Ground mounting kit:
4a Lag screws
4b Nut
4c Washer
4d Plug
4e Base plate
5 Manual release handle assembly
6 Handle locking key
7 End limit brackets
Copyright © 2012 Somfy SAS. All rights reserved
Ref.
9014597
9014598
x 1
x 2
x 1
x 4
x 8
x 4
x 4
x 1
x 1
x 2
x 2
1
2
4
a
4
b
4
4
e
6 5
Elixo 500 3S io
3
c
4
d
7
3