Memorising The Keytis Io Remote Controls - SOMFY ELIXO 500 3S io Manuel D'installation

memorising by copying a previously memorised keygo io remote control
This operation is used to copy the programming from a previously memorised remote control button.
[1]. Press the outer left and right buttons on the previously memorised remote control together until the green indicator light flashes.
[2]. Press and hold the button to be copied on the previously memorised remote control for 2 seconds.
[3]. Briefly press the outer left and right buttons on the new remote control together.
[4]. Briefly press the selected button to actuate the motorisation on the new remote control.
remote control memorised

memorising the keytis io remote controls

The Keytis io remote control system key memorising and copy memorising operations can only be carried out at the installation site.
To obtain authorisation to transfer its system key or programming, the previously memorised remote control must be able to establish
radio communication with a receiver on the installation.
If the installation already includes other io-homecontrol® products with at least one memorised bidirectional remote control, the Keytis
io remote control must first memorise the system key (see below).
A previously memorised button cannot be memorised on a second receiver. To find out whether a button has already been memorised, press it:
• button already memorised → green indicator light comes on.
• button not memorised → orange indicator light comes on.
To clear a previously memorised button, refer to the section entitled Clearing individual buttons on the keytis io remote control.
button functions on a keytis io remote control
• F0 or F1 memorisation: COMPLETE opening control by pressing and holding and PEDESTRIAN opening control by briefly pressing the button
• F2 memorisation: remote lighting control ON/OFF by briefly pressing the button
• F3 memorisation: auxiliary output control ON/OFF by briefly pressing the button
memorising the system key
. This step must be performed if the installation already includes other io-homecontrol® products with at least one memorised bidirectional
remote control.
. If the Keytis io remote control to be memorised is the first remote control on the system, go directly to the step "Memorising the Keytis
io remote control".
[1]. Setting the memorised remote control to key transfer mode:
• Keytis io, Telis io, Impresario io, Composio io remote controls: press the "kEy" button until the green indicator light comes on (2 s).
• Other remote control: refer to the instructions.
[2]. Briefly press the "kEy" button on the new remote control. Wait for the confirmation beep (a few seconds).
Copyright © 2012 Somfy SAS. All rights reserved
2s
remote control memorised
remote control to be memorised
remote control to be memorised
Elixo 500 3S io
17