Memorising Safety Edge Transmitters; Memorising A Resistive Safety Edge Transmitter; Memorising An Optical Safety Edge Transmitter; Clearing The Remote Controls - SOMFY ROLLIXO io Manuel D'installation

Rollixo io

MEMoRIsING sAfEty EDGE tRANsMIttERs

Memorising a new radio safety edge transmitter overwrites the previous transmitter.

Memorising a resistive safety edge transmitter

The transmitter must already be installed and the resistive safety edge
must be connected to the transmitter.
[1]. Press button
on the receiver until the indicator light comes on permanently.
Prog
[2]. Press the button on the back of the safety edge transmitter 5 times.
The safety edge transmitter indicator light comes on with each press and
after the 5th press remains constantly lit for 4 seconds and then flashes for
4 seconds.
Indicator light 2 on the receiver goes out and the receiver Prog indicator
light will flash and then go out (this may take a few seconds, the time required
for the transmitter and receiver to communicate with each other).
The transmitter is memorised in the receiver.
[3]. Restart the magnet recognition procedure (see page 10).

Memorising an optical safety edge transmitter

[1]. Press button
on the receiver until the indicator light comes on permanently.
Prog
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4 seconds.
Indicator light 2 on the receiver goes out and the receiver Prog indicator
light will flash and then go out (this may take a few seconds, the time required
for the transmitter and receiver to communicate with each other).
The transmitter is memorised in the receiver.

CLEARING thE REMotE CoNtRoLs

Clearing individual buttons on the keytis io or keygo io remote controls

This can be done:
• by memorising via the programming interface.
Memorising a button which has already been memorised will clear this button's function.
• by clearing directly on the remote control (only on Keytis io remote controls).
Press the "PRoG" button and the ButtoN to be cleared on the remote control together.

Clearing all remote controls

Press button on the receiver (for approximately 7 seconds) until the indicator light above it goes out.
Prog
Release button on the receiver when the indicator light goes out; the indicator light flashes slowly.
Prog
All memorised remote controls and the system key will be cleared.
Prog
20
Prog
Press and hold down for 7 seconds
1 2 3 4
STOP
x5
1 2 3 4
STOP
1 2 3 4
STOP
4s
1 2 3 4
STOP
Prog Prog
1 2 3 4
Prog
STOP
Safety edge
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
Prog
Copyright © 2012 Somfy SAS. All rights reserved
Prog
Prog
Prog
Prog