SOMFY ELIXO 500 3S io Manuel D'installation page 61

Code description values (bold = default)
P19 Closing speed 1: slowest speed
at
10: fastest speed
default value: 5
P20 Opening speed 1: slowest speed
at
10: fastest speed
default value: 5
P21 Closing slowdown zone 1: shortest slowdown zone
at
5: longest slowdown zone
default value: 1
P22 Opening slowdown 1: shortest slowdown zone
zone at
5: longest slowdown zone
default value: 1
P25 Closing torque limitation 1: minimum torque
at
10: maximum torque
adjusted at the end of auto-
programming
P26 Opening torque 1: minimum torque
limitation at
10: maximum torque
adjusted at the end of auto-
programming
P27 Closing slowdown 1: minimum torque
torque limitation at
10: maximum torque
adjusted at the end of auto-
programming
P28 Opening slowdown 1: minimum torque
torque limitation at
10: maximum torque
adjusted at the end of auto-
programming
P33 Obstacle detection 0: low sensitivity
sensitivity 1: low sensitivity
2: standard
3: high sensitivity
P37 Wired control inputs 0: complete cycle mode -
1: opening mode - closing
P40 Coupling speed when 1: slowest speed
closing at
4: fastest speed
default value: 2
P41 Coupling speed when 1: slowest speed
opening at
4: fastest speed
default value: 2
Copyright © 2012 Somfy SAS. All rights reserved
setting
completed
pedestrian cycle
Comments
If this parameter is modified, it is essential to perform the force measuring procedure at
the end of the installation operation or to install a safety edge.
If this parameter is modified, it is essential to perform the force measuring procedure at
the end of the installation operation or to install a safety edge.
If the torque is too low, there may be erratic obstacle detection.
If the torque is too high, the installation may not comply with the standard.
If this parameter is modified, it is essential to perform the force measuring procedure at
the end of the installation operation or to install a safety edge.
0: terminal 9 input = pedestrian cycle, terminal 11 input = complete cycle
1: terminal 9 input = opening only, terminal 11 input = closing only
If this parameter is modified, it is essential to perform the force measuring procedure at
the end of the installation operation or to install a safety edge.
Elixo 500 3S io
15