SOMFY ELIXO 500 3S io Manuel D'installation page 64

Masquer les pouces Voir aussi pour ELIXO 500 3S io:

Manuel d'utilisation (96 pages)

Manuel d'installation (80 pages)

Manuel d'installation (60 pages)

Table des Matières

Les langues disponibles

Elixo 500 3S io

memorising via the programming interface

If the installation already includes other io-homecontrol® products with at least one memorised bidirectional remote control, the Keytis io remote control must

first memorise the system key (see page 17).

[1]. Press and hold the "ProG" button (2 s) on the programming interface.

Note: Pressing "ProG" again allows the next function to be memorised.

Memorising the Keytis io remote control in F0 or F1 mode enables the gate to be controlled in complete opening mode by pressing and holding, and

in pedestrian opening mode by briefly pressing the selected button to actuate the motor.

[2]. Briefly press the "ProG" button on the remote control.

Wait for the second beep and the green indicator light to start flashing rapidly.

This may take from a few seconds up to around 1 minute, depending on the number of products present in the system.

[3]. Briefly press the selected button to actuate the motor.

The remote control emits a confirmation beep.

memorising by copying a previously memorised keytis io remote control

• Complete copying of a keytis io remote control

This operation is used to copy all the buttons on a previously memorised remote control.

The new remote control must not be memorised for another automatic control system.

Ensure that the new remote control has memorised the system key.

[1]. Press the "ProG" button on the memorised remote control until the green indicator light comes on (2 s).

[2]. Briefly press the "ProG" button on the new remote control.

Wait for the second beep and the green indicator light to start flashing rapidly (a few seconds).

remote control memorised

• Copying individual buttons on the keytis io remote control

This operation is used to copy the memorisation of a single button on a previously memorised remote control to a blank button on a new remote control.

Ensure that the new remote control has memorised the system key.

[1]. Press the "ProG" button on the memorised remote control until the green indicator light comes on (2 s).

[2]. Briefly press the button to be copied on the previously memorised remote control.

[3]. Briefly press the "ProG" button on the new remote control.

Wait for the confirmation beep (a few seconds).

[4]. Briefly press the selected button to actuate the motor on the new remote control.

remote control memorised

It is not possible to memorise Keytis io remote controls in the following cases:

. The remote control has not memorised the system key.

. Several of the installation's receivers are in programming mode.

. Several remote controls are in key transfer or memorisation mode.

Incorrect memorisation is indicated by a rapid series of beeps accompanied by a flashing orange indicator light on the Keytis remote