Switch On And Off; Adjustment; Light / Head With Proximity - Faro ALYA Mode D'emploi

Lampada dentale a led
Masquer les pouces Voir aussi pour ALYA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4. ISTRUCTION FOR USE
Read paragraph 1 carefully for safe use of the device.
The device must be clean before use (see Device Cleaning paragraph).
4.1
Refer to §1.1 for the switch on and adjustment symbols.
Complete Light
To switch on and off the light, press and release the joystick lever using the right or left side.
The light intensity on switch on will always be the last used before switch off.
Complete light with Theia Tech
Same operations of the complete light plus those on the fixed arm switch on and/or off in
sync with that of the head.
The light on the fixed arm can be switched on/off even using the button on the arm. If the
light is switch on, the light will be automatically synchronised, if the light on the head is off,
it will be regulated to maximum intensity.

4.1.1 Adjustment:

a) to reduce light intensity keep the lever pressed on the joystick on the left side (light rear
view) until the desired intensity is reached.
On reaching the minimum intensity, you will hear an acoustic signal (1 beep).
a) to increase light intensity keep the lever pressed on the joystick on the right side (light rear
view) until the desired intensity is reached.
On reaching the maximum intensity, you will hear an acoustic signal (1 beep).
c) to skip to maximum intensity, press and release the joystick lever using the front or rear
side. On subsequent pressing on the front or rear side, the light intensity will return to that
previously saved.
The light on the fixed arm is adjusted in sync with that of the head, it cannot be adjusted
independently.

4.1.2 Light / Head WITH PROXIMITY

Switch on/off
Complete Light: To switch on or off, approach the sensor once up to a maximum distance of
3 cm.
Complete light with Theia Tech: same operations of the complete light plus the light on the
fixed arm switch on and/or off in sync with that of the head.
Adjustment
Complete light: To adjust light intensity, you need to stay still near the sensor until the desired
intensity is obtained. Adjustment enables passage from the maximum value to the minimum
value again to the maximum. On reaching the maximum intensity, you will hear an acoustic
58
signal (2 beeps). On reaching the minimum intensity, you will hear an acoustic signal (1 beep).
Attention
S imultaneous use of the light with electro-surgical scalpels can cause its
malfunctioning.
Attention
The control joystick must be handled with care to avoid breakages. Never
move the light using the joystick to grip.
Note
Each time you switch on the light, the light intensity will be saved on previous
switch off.
Warning - danger of contact with powered parts
do not use the device if parts or casing are damaged.

SWITCH ON AND OFF

Publicité

Table des Matières
loading

Table des Matières