Safe Working Load; Complete Combined Version Light Assembly - Faro ALYA Mode D'emploi

Power supply
Complete
light version
with
Theia
Tech
24Vdc
Tab 1 – Requirements for electrical connection and compliance with IEC 60601-1.
Check the packaging contains the following parts:
- Dental light / Head (in the required version)
- Sheet to download for site instructions www.faro.it/download

3.2.2 Safe working load

The dental light EDI Led type suits various installation positions:
DENTAL UNIT, CEILING, WALL, FLOOR.
SAFE WORKING LOAD
Mobile arm 855 mm
Mobile arm 550 mm

3.2.3 Complete combined version light assembly

With a digital level, ensure the connection element is perfectly parallel to the ground.
Install the light by inserting the light terminal pin in the specific combined compartment.
Connect the power supply cable according to the specifications outlined in Tab. 1.
Check the light stays balanced in all positions. If necessary, use the adjustment system on the
spring to balance the light.
Check switch on and adjustment and (if present) the Auto-on command and the remote cable.
46
Type of power supply and
Power cable
safety requirements
transformer complies with
IEC/EN 60601-1 third edition
2 x 0.5 mm2
and IEC/EN 60601-1-2 with
300 V
thermal protection or protection
105°C
downstream with at least one
PVC insulation
appropriate fuse:
diameter
• T2AL 250V
insulation 1.85
Minimum requirements:
mm
• Output: 24 Vdc;
Only use certified
• Power 28 VA
terminals and
• Class B;
connectors with
• Rigidity over 4000 V.
resistance to
Thermal protection
flame V1 or
similar.
Total load
(SAFE WORKING LOAD) (MINIMUM BREAKING LOAD)
29.2 N
25.6 N
Compliance with
Classification
IEC 60601-1
The medical
system must be
declared compliant
with IEC/
EN60601-1 by
the installation
technician or
manufacturer.
Component
Note for the
built-in
installation
technician: ensure
the combined
version on
which the light
is installed is
certified to host the
complete light.
Safety load
235 N
205 N