Instructions For Use; Switching On/Off Adjustment; Adjustment; Lamp With Remote Control - Faro MP 3020 Mode D'emploi

4. inSTRUcTiOnS FOR USe

4.1 Switching on/off adjustment

To turn the lamp on and off, press and release the joystick lever to the left or right side.

4.2 Adjustment

a) to reduce light intensity, keep the joystick lever pressed to the left side (rear view of
lamp) until it reaches the desired intensity. When it reaches the minimum intensity, the
machine will beep once.
b) to raise the light intensity, keep the joystick lever pressed to the right side (rear view of
the lamp) until it reaches the desired intensity. When it reaches the maximum intensity,
the machine will beep twice.
c) to go to the minimum intensity immediately, press and release the joystick lever to the
front or rear. The next time the joystick is pressed and released to the front or rear, it will
revert back to the previously memorized intensity.
The lamp memorises the last setting. Each time the lamp is switched on the light intensity
will be the same as when it was turned off.
The control lever must be managed with care to prevent breakage.
Do not use the control lever for the movement of the whole lamp.
4.3 Lamp With Remote Control (optional)
To switch the lamp on or off, press and release the button marked "A" (fig 2).
Adjustment:
a) to reduce light intensity keep pushed the button "A" until the desired intensity is
reached. When the minimum intensity is reached, an acoustic signal will be heard (1
beep).
b) To increase the light intensity keep pushed the button "A" until the desired intensity is
reached. When the maximum intensity is reached, an acoustic signal will be heard (2
beeps).
c) to reach the minimum light intensity immediately, press the button marked "B" (fig
2). When the minimum intensity is reached an acoustic signal will be heard (1 beep).
Press the button again to restore previously selected light intensity.
!
20
The lamp memorises the last adjustment. Each time the lamp is turned on, the
light intensity will be the same as when it was turned off.