Light / Complete Light With Theia Tech / "Alya" Head; With Remote Control - Faro ALYA Mode D'emploi

Note
Each time you switch on the light, the light intensity will be saved on previous
switch off.
Complete light with Theia Tech same operations of the complete light plus the light on the fixed
arm will adjust in sync with that of the head.
4.1.3 Light / Complete light with Theia Tech / "ALYA" head WITH REMOTE CONTROL
Switch on / Switch off / Adjustment
- To switch on and/off press and release button "A".
- Adjustment:
a) to reduce the light intensity keep button "A" pressed until reaching
the desired intensity.
On reaching the minimum intensity, you will hear an acoustic signal (1 beep).
b) to increase the light intensity keep button "A" pressed until reaching
the desired intensity.
On reaching the maximum intensity, you will hear an acoustic signal (2 beeps).
c) to immediately reach the minimum light intensity, press button "B".
On reaching the minimum intensity, you will hear an acoustic signal (1 beep).
Subsequent button pressing will bring the light back to the previous light intensity
selected.
Note
Each time you switch on the light, the light intensity will be saved on previous
switch off.
4.1.4 LAMP / COMPLETE LAMP WITH THEIA TECH / "ALYA" HEAD WITH SYNCHRO-
NIZATION COMMAND
Where foreseen, it is possible to connect the Alya lamp to the Faro environment lamp in wireless
mode in order to turn them into a synchronized lighting system named "Synchro".
The "Synchro" mode has been purposefully designed to improve the comfort of the medical den-
tist/orthodontist, in order to reduce the effect of glare generated when passing from observation
of a highly illuminated surface (e.g. oral cavity with a dental lamp) to a poorly lit surface (e.g.
dental quiver).
With the method named "Synchro", activatable using the button situated at the head of the Alya
lamp, it is possible to change the illumination produced by the Faro environment lamp automati-
cally on the basis of the value of illumination produced by Alya.
Note: Between the dental lamp and the environmental one, a small delay in synchronization may
be experienced. This is due to the communications protocol. This effect is normal and does not
signify a defect.
The "Synchro" function, in order to be enabled, requires a "Pairing" process (which should only
be carried out once) in order to create a link between the two lamps Subsequently, the "Synchro"
function can be enabled and/or disabled as required by the user, from the button situated on the
dental lamp.
"PAIRING" PROCEDURE
NOTE:
• The "Pairing" procedure is only necessary at the first connection, although it can be
repeated in the event of changing the Alya lamp or the electronics of one of the two inter-
connected lamps.
59