Storage And Use: Environmental Provisions; Atmospheric Pressure; Requirements For Electromagnetic Compatibility - Faro ALYA Mode D'emploi

The product is covered by WEEE Directive 2012/19/EU
To scrap and dispose of the materials, comply with the standard in force in your country, if
necessary contacting recognised and authorised specialist companies.
At the end of the life cycle, divide the materials based on their type (ferrous, rubber, plastic).
Do not leave small parts of the equipment unguarded or within reach of exposed people
(children) because they are a potential sources of danger.
The company FARO does not allow any changes to the product not expressly authorised in
writing, otherwise conformity to the safety standards and the warranty expires.
Other warnings are outlined in the titles of this manual.
1.5

STORAGE AND USE: ENVIRONMENTAL PROVISIONS

The appliance in the original packaging can be transported or kept in a warehouse for a period
of 15 weeks if the following environmental conditions are met:
• Environmental temperature from -20°C to + 70°C
• Relative humidity from 10% to 90%
• Atmospheric pressure from 500 to 1060 mbar
The appliance must be used in the following environmental conditions:
• Temperature from 10° to 40°C
• Max altitude: 2000 m
• Relative humidity from 30% to 75%

ATMOSPHERIC PRESSURE

1060 mbar
800 mbar
1.6

REQUIREMENTS FOR ELECTROMAGNETIC COMPATIBILITY

This medical device requires particular precautionary measures to ensure electroma-
gnetic compatibility, and must be installed and used in compliance with the information
provided in the accompanying documentation.
Manufacturer's guide and declaration – Electromagnetic emissions
The ALYA lamp is made to function in the electromagnetic environment specified below. The client or user should make sure that it is
Emission tests
RF Emission CISPR15
RF Emission CISPR15
Harmonic emission
RF Emission
CISPR11 / EN 55011
RELATIVE HUMIDITY
75% RH
30% RH
effectively used in this environment.
Conformity
The ALYA lamp uses RF energy only for internal functioning.
Yes Therefore, its RF emissions are very low and probably do not
cause any interference with other nearby electronic equipment.
Yes
The ALYA lamp is suitable for use in all buildings, including do-
mestic buildings and those connected directly to the low voltage
Class C public electricity mains that power domestic buildings.
The ALYA lamp is not suitable for interconnections with other
Yes
devices (ceiling model).
USE TEMPERATURE
40°C
10°C
Guide – Electromagnetic environment
39