Storage; Acceptance & Transfer; Inspection And Transfer - Mizuhosi 5803 Manuel Du Propriétaire

1.4 Storage

When not in use, store in a clean, dry environment with temperature between 32°F and
120°F (0° C to 49°C).
It is recommended that the 5803 Base be stowed with the power cord plugged into a
proper AC receptacle with the on/off power-switch "on" to assure batteries are fully
charged and ready for service.
If recharge is required, charge a minimum of 3 hours. A full charge should be
available after 18 hours.
1.5 Acceptance & Transfer
Upon receipt of your table, remove the table from the shipping crate following the
unpacking instructions. Visually inspect all surfaces for freight damage. Check each
caster for proper rolling operation.
NOTE: Any freight damage must be reported to the freight carrier immediately upon
delivery. It is the responsibility of the recipient to make freight damage claims.
1. Read the model/serial number identification label found at the head end of the base
(see figure 4) to confirm the serial number and the input power requirements.
2. Perform pre-op function check; see section 5.0.

1.6 Inspection and Transfer

Before use, inspect the device for possible damage, excessive wear or non-functioning
parts. Carefully inspect all critical, inaccessible areas, joints, electrical cords and all
movable parts for possible damage or non-function.
Damaged or defective products should not be used or processed. Contact your local
MIZUHO OSI sales representative for repair or replacement.
MIZUHOSI 2009 NW0498 Rev E
6