Foot End Cover; Hand Pendant Module - Mizuhosi 5803 Manuel Du Propriétaire

9.2 Foot End Cover

1. Switch off the base at the circuit breaker and disconnect the power cord from the
source.
2. Remove the foot end base covers.
3. Disconnect the negative wires at the battery terminals.
4. Remove the foot end cover screws.
5. Carefully lift foot end cover up and off.
Screws

9.3 Hand Pendant Module

1. Switch off the base at the circuit breaker and disconnect the power cord from the
source.
2. Unscrew hand pendant cord-connector from base receptacle.
3. Unplug hand pendant cord connector from the base.
MIZUHOSI 2009
Foot End Base Cover
Figure 15: Foot End Cover Removal
31
Screws
NW0498 Rev E