Hand Pendant - Mizuhosi 5803 Manuel Du Propriétaire

4.2 Hand Pendant

Each 5803 Advanced Control Base is equipped with a hand-held pendant, which is on a
storage bracket attached to the head end. The hand pendant allows the operator to
manipulate the table into trendelenburg, reverse trendelenburg, and lateral roll (tilt)
positions. The selected function will continue to operate until the button on the hand
pendant is released.
NOTE: It is recommended that a table top always be connected between the head and
foot ends when operating the powered controls.
Indicator
Lights
Height Up
Trendelenburg
Left Lateral
Roll (Tilt)
Indicator
Lights
Figure 8: Hand Pendant
MIZUHOSI 2009
To raise the table, depress the
height up button on the left side of
the control with the arrow that points
in the "up" direction.
To lower the table, depress the
height down button on the right side
of the control with the arrow that
points in the "down" direction.
To
Height
depress the button on the left with
Down
the arrow that indicates foot up until
the desired trendelenburg angle is
Reverse
achieved. This lowers the head end
Trendelenburg
column and raises the foot end
column simultaneously. If the table is
Right Lateral
in a fully lowered position, only the
Roll (Tilt)
foot end will raise to achieve the
desired trendelenburg angle.
To reverse
table, depress the button on the right
with the arrow that indicates foot
down
trendelenburg angle is achieved.
This raises the head end column and
lowers
simultaneously. If the table is in a
fully raised position, only the foot end
will lower to achieve the proper
reverse trendelenburg angle.
To laterally tilt to the left, depress
the left lateral roll button on the left
side of the control.
To laterally tilt to the right, depress
the right lateral roll button on the
right side of the control.
11
trendelenburg the
trendelenburg
until the desired
the foot end
NW0498 Rev E
table,
the
reverse
column