Mizuhosi 5803 Manuel Du Propriétaire page 16

9. Rotate the 180° rotation lock handle clockwise until it is engaged (lock indicator light
is illuminated).
10. The tilt drive is now synchronized to the crossbars, and the crossbars are
synchronized to each other.
Case 2: A table top is not coupled to the base
1. Turn power switch on.
2. Turn off the rotation safety lock. The switch should not be illuminated.
CAUTION: This allows the foot end crossbar to rotate freely; any load on the
crossbar can make it swing.
3. Rotate the 180° rotation lock lever counter-clockwise until it is disengaged.
CAUTION: This allows the head end crossbar to rotate freely; any load on the
crossbar can make it swing.
4. The tilt drive mechanism will automatically return to the middle of its range. While
this occurs, you will hear the tilt motor running, and the head end crossbar may
rotate.
5. When the tilt motor stops, observe the tilt drive status light. If it is illuminated, then
the tilt drive is in the middle of its travel range.
6. Manually level the head end crossbar.
7. Manually level the foot end crossbar.
8. Turn on the rotation safety lock switch. The switch should illuminate.
9. Rotate the 180° rotation lock lever, clockwise, until it is engaged (lock Indicator light
is illuminated).
10. The tilt drive is now synchronized to the crossbars and the crossbars are
synchronized to each other.
MIZUHOSI 2009
16
NW0498 Rev E