Head End Slider Adjustment Procedure - Mizuhosi 5803 Manuel Du Propriétaire

10.4 Head end Slider Adjustment Procedure

Overview:
With one of the Mizuho OSI modular (interchangeable) table tops attached to the 5803
Advanced Control Base, in-line movement of the head end slider (or trolley assembly) is
required to accommodate trendelenburg and reverse trendelenburg positioning.
Periodic adjustment may be needed to maintain proper friction of movement.
Tools Required:
Hex (Allen) Key, 5/64-inch
Force Gauge, to 25-pounds pushing force.
Procedure:
1. Turn on/off power switch to off, disconnect power cord from power source (AC wall
outlet), allow 30 seconds for discharge.
2. Remove head end pivot assembly cover per procedure.
3. Some models may have a set screw installed in front of the spring plunger. This
screw must be removed prior to adjustment. Using 5/64-inch hex key, adjust Slider
spring plunger (shown below) as needed.
4. Using force gauge pushing on rotating crossbar, verify head end slider assembly
(without any top attached) moves in-line to its stops, in both directions, uniformly,
with 20 to 25 pounds of force applied.
Figure 18: Head End Pivot Assembly, Left Side (cover removed)
MIZUHOSI 2009
39
NW0498 Rev E