Cleaning And Maintenance; Cleaning And Disinfecting; Lubrication - Mizuhosi 5803 Manuel Du Propriétaire

6.0 CLEANING and MAINTENANCE

6.1 Cleaning and Disinfecting

After completion of each surgery, wipe the 5803 Advanced Control Base with a
quaternary disinfectant. Dry the base completely.
NOTE: The head end and foot end columns of the 5803 Advanced Control Base are
not sealed, therefore:
 Never pour any liquid directly onto the table.
 Never allow any liquid to enter the extensile joint of the columns.
 Never subject the 5803 Advanced Control Base to an equipment washing machine.
Failure to thoroughly dry any surface after cleaning and disinfecting may result in rust.
It is important to dry the base to prevent rusting. Rust formation can prematurely
shorten the useful life expectancy of the 5803 Base.
USE OF IODOPHORS WILL CAUSE STAINING:
Base Exterior:
 Exterior surface should be regularly wiped clean with a mild detergent solution and
wiped dry with a soft lint-free cloth.
 Care should be taken to avoid exposing the base to excessive moisture. Flooding,
fogging or steam cleaning is not recommended and will void any warranty.
 Blood or other fluids, etc., if allowed to remain on the base for a long period of time,
will require special cleaning to remove. A 5% acetic acid solution or white vinegar
and water solution is especially good for this purpose.
 Cleaning with a good commercial cleaning compound, such as stainless steel Magic
or acme white finish, and then buffing the surface by hand can correct staining and
discoloration of plated or stainless steel surfaces.
 To disinfect exterior surface use a quaternary ammonium or similar type disinfectant
compound according to manufacturer's directions for use. Wipe dry with a soft lint-
free cloth.
 Casters should be cleaned and disinfected in the same manner as base exterior.

6.2 Lubrication

Base Exterior:
Following a thorough cleaning and decontamination of the base, silicone lubricant spray
may be used on most of the exposed inner head and foot columns and inner retractable
beam. No other lubrication is necessary.
Base Interior:
All of the internal moving parts of the 5803 base receive factory lubrication which, under
normal use, provides lubrication for the life of the equipment.
MIZUHOSI 2009
24
NW0498 Rev E