Rotation Lock Indicator; Tilt Drive Status Indicator - Mizuhosi 5803 Manuel Du Propriétaire

4.3.2 180° Rotation Lock Indicator
When illuminated, the 180° rotation lock indicator light indicates the lock is
engaged and the table cannot be rotated 180°. If the 180° rotation lock indicator
is not illuminated, turn the rotation lock lever clockwise until the light is
illuminated.
NOTE: If a 180° patient rotation is to be performed, the rotation lock lever should
be rotated counterclockwise approximately one half rotation past the point that
the rotation lock indicator light goes out. Rotating the lock lever to this point
lessens the drag of the friction control, thereby allowing the table tops to rotate
more freely during the rotation. If even less friction is desired, the lock lever may
be rotated further counterclockwise, as necessary. If more friction is desired,
rotate handle clockwise.
After the patient rotation is complete, rotate the rotation lock lever clockwise until
the rotation lock indicator light is illuminated.
When the rotation lock indicator light is not illuminated, the table top is
UNLOCKED regardless of how much the lock lever has been turned clockwise or
counterclockwise. Always turn the lock lever until the rotation lock indicator light
is illuminated after a 180° rotation.

4.3.3 Tilt Drive Status Indicator

The tilt drive status indicator light is illuminated when the powered lateral tilt drive
mechanism is in the center position of the +/- 25- lateral tilt range. If the tilt drive
status indicator is not illuminated, operate the lateral tilt function using the hand
pendant in the appropriate direction until the indicator is illuminated. The head
end crossbar should be horizontal when the tilt drive status indicator is
illuminated. If the head end crossbar is not horizontal, the internal power tilt
mechanism is out of synchronization with the crossbar. Refer to section 4.4
synchronizing the lateral tilt function to reset this function.
MIZUHOSI 2009
WARNING:
14
NW0498 Rev E