Retracting The Base For Storage - Mizuhosi 5803 Manuel Du Propriétaire

4.11 Retracting The Base For Storage

The 5803 Advanced Control Base retracts for storage (refer to Section 1.2 for Length
and Width specifications).
To retract the base:
1. Lock the head end casters and unlock the foot end casters.
2. Loosen the retracting locking knob on the center beam (see figure 13).
NOTE: This knob will become completely separated from the base if rotated many
times.
3. Push the foot end of the base toward the head end of the base until the foot end is
retracted to its minimum length.
4. Tighten the locking knob.
Head end
MIZUHOSI 2009
Figure 13: Retracting the 5803 Advanced Control Base
Retract
Retracting
Lock Knob
21
Foot End
NW0498 Rev E