Transducer Maintenance; Default Configuration Of 8025 Batch Controller On Delivery - Burkert 8025 Notice D'utilisation

5 MAINTENANCE
5.1.3. «ERROR» prompts
ERROR 1 displayed at the starting up of the transmitter indicates a read error of the
totalizers: cut off the power of the device then power the transmitter again. If ERROR 1 is
still displayed, press ENTER: the values of the totalizers are displayed. These values are
probably false: enter the CALIB menu to reset the totalizers and come back to the normal
operating of the transmitter.
ERROR 2 displayed at the starting up of the transmitter indicates a read error of the
calibration parameters (unit, K factor,...): cut off the power of the device then power the
transmitter again. If ERROR 2 is still displayed, press ENTER to load the default values
and program the transmitter again through the CALIB menu. The totalizers are not reset.
ERROR 3 displayed at the starting up of the transmitter indicates a read error of the
totalizers and the calibration parameters (unit, K factor,...): cut off the power of the device
then power the transmitter again. If ERROR 3 is still displayed, press ENTER to reset the
totalizers if necessary and program the transmitter again through the CALIB menu.

5.2. Transducer maintenance

Provided the installation and the operating conditions are satisfactory, the Batch
Controller does not need any particular maintenance. If clogging occurs, the parts of the
transducer which are immersed (vane, spindle, bearings) can be cleaned with water or any
other cleaning agent suitable for use with PVDF.

5.3 Default configuration of 8025 Batch Controller on delivery

Language:
Unit flow:
Unit totalizers: L
Unit batch:
K-Factor:
Batch option:
Quantities V1 to V7:
english
L/s
L
001.00
MEM+MANU
00000
E-42-
BATCH CONTROLLER 8025
Overfill correction:
Alarm DURING: On, DEL1 = 100
Alarm AFTER: On, DEL2 = 100
Relay 1:
Relay 2:
yes
DEL = 000
100 %
inversion: N°
VALVE
inversion: N°