Burkert 8025 Notice D'utilisation page 60

3 INSTALLATION
3.2 Installation
Installing a compact version
1. The fitting must be installed into the
pipe according to the installation
specifications in section 3.1.
2. Insert plastic nut
plastic ring snap into guide bush
3. Carefully insert batch controller 8025
into fitting. If installed properly, the
transmitter cannot be rotated.
4. Tighten transmitter housing to fitting with
plastic nut .
Plastic nut must only be
tightened by hand!
Installing a panel-mounted version
Follow the instructions below to install the device into a panel:
1. Use the supplied drilling jig to cut away the necessary opening in the panel. Make sure
to scrupulously respect the dimensions indicated.
2. Place the gasket on the 4 screws of the cover.
Note: Use the 4 M4x25 screws supplied if the panel door is too thick.
3. Place the cover+gasket set on the cut-away with the electronic board facing the inside
of the panel.
4. Insert the 4 washers onto the 4 screws and fit the device to the panel using the 4 nuts.
5. Connect according to instructions described in chapter 3.3.
6. Use the supplied 4 cable clips to fit the cables to the protective plate.
into fitting and let
.
BATCH CONTROLLER 8025
Fig. 3.2 Mounting 8025 compact
E-10-